Additional Information
| Application | Pulse/ direction ±10V RS232/ RS422/ RS485 |
|---|---|
| Unbalance Asynchronous Serial Interface | 5VTTL 19.2kbaud Full Duplex |
| Balance Asynchronous Serial Interface | RS422 19.2kbaud Full Duplex |
| Analog Input | ±10V |
| Pulse Inputs | RS422 2.5MHz or 150kHz (LP) |
| Pulse Outputs | RS422 |
| Digital User Inputs | No |
| Digital User Outputs | Motor status 2xNPN 25mA |
| Ext. Connector Type | Cable Glands |
| Protection | IP67 / IP65 on MAC400-800 |
Details
Low cost module that can be used for pulse/direction or ±10V analogue control. Tha analog input can also be used in open loop to control position, velocity or toque. Encoder output for external master controller that close the loop. When the module is mounted it is not possible to access the motor with a serial interface. If this is wanted use the MAC00-Bx module where you have CS functionality but also RS232 and RS485 interface. The module is normally used when the machine builder sets up the MAC motor, without module mounted, with the special cable RS232-9-1-MAC. Thereby the end user can not by mistake access and change any parameters. The module do not contain any electronics so all the basic MAC motor signals are available in the cable.
Compare Products
You have no items to compare.
My Cart
You have no items in your shopping cart.
